PA Rigging / L-Acoustics / L2

L2

Rigging field guides for the L2/L2D line array, built from L-Acoustics' official L2 Owner's Manual (version 5.0). Each opens as an on-site checklist with a Focus mode toggle.

1. L2 — Securing on Chariot

Unpacking L2/L2D and cradling it in L2-CHARIOT/L2D-CHARIOT with L2-ROLL straps.

2. L2 — Securing LA-RAK III on L2-BUMP

Mounting an LA-RAK III amplified rack on L2-BUMP with LA-RAKMOUNT rails.

3. L2 — Flying with L2-BUMP and L2-BAR

Building a flown array under L2-BUMP, enclosure by enclosure, off individual chariots.

4. L2 — Flying with L2-RIGBAR

Flying a smaller array directly under the single-motor L2-RIGBAR.

5. L2 — Flying with L2-SCREEN/L2D-SCREEN

Building a flown array while fitting each enclosure's front screen and side panels.

6. L2 — Adding a Pullback with L2-RIGBAR

Adding a pullback to the bottom of a completed array to set a horizontal array's angle.

7. L2 — Attaching K2-JACK Stabilizers

Fitting K2-JACK stabilizers to a chariot so a ground-stacked array clears its wheels.

8. L2 — Adjusting Chariot Site Angle

Setting site angle on K2-JACK — screw jacks on L2-CHARIOT, tilt pins on L2D-CHARIOT.