PA Rigging / L-Acoustics / L2 / Flying with L2-RIGBAR

L2 — Flying an Array L2-RIGBAR

Flying an L2/L2D array directly under L2-RIGBAR — a single, lightweight rigging bar for smaller arrays that don't need L2-BUMP or a rack. Reference: LA-L2-FLY-RIGBAR-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

0/ complete

Not saved anywhere — resets when you leave this page.

Safety notes

Minimum 2 operators. Rigging accessories: L2-RIGBAR, 2 Ø19 mm shackles WLL 3.25 t.
Risk of falling objects — verify no unattached items remain on the product or assembly.
When flying an array, use the available holes to implement a secondary safety.

Prerequisite

Each L2/L2D to be flown is already secured to its own chariot. See Securing on L2-CHARIOT/L2D-CHARIOT.

Rigging L2-RIGBAR

Secure L2-RIGBAR on top of the enclosure using the ball-locking pins — secure it at the front for a positive initial site angle, or at the back for a negative initial site angle. Secure L2-RIGBAR to the sling using two Ø19 mm shackles WLL 3.25 t — always implement a secondary safety using the bar's available holes.

Building the Array

Remove the chariot from the enclosure, raise the array, and add more L2/L2D as necessary, following the same enclosure-to-enclosure sequence used when flying with L2-BUMP and L2-BAR.

Source: L-Acoustics L2 Owner's Manual, EN, v5.0. Rigging procedures, pp.107-108.