PA Rigging / L-Acoustics / L2 / Securing on L2-CHARIOT/L2D-CHARIOT

L2 — Securing on Chariot L2-CHARIOT / L2D-CHARIOT

Unpacking a fresh-from-the-crate L2 or L2D and cradling it in its chariot dolly using L2-ROLL handling straps — the prerequisite step before flying or stacking any L2/L2D array. Reference: LA-L2-CHARIOT-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

0/ complete

Not saved anywhere — resets when you leave this page.

Safety notes

Minimum 2 operators. Tools: screwdriver with 8 mm hex bit.
L2-ROLL is a temporary handling tool, not a long-term rigging accessory — do not use it for rigging.
Never position L2D on its narrow edge, even temporarily.
Inspect L2-ROLL before use — do not use it if any fraying, deformation, or other safety issue is detected.

Rigging the Straps

Remove the top lid and main body of the delivery packaging. Make sure each L2-ROLL strap is secured to one ring with a lark's head knot. On each side of the enclosure, remove the screw at the center of gravity using the screwdriver with an 8 mm hex bit — retain the screws for reassembly. Tighten the L2-ROLL rings to the enclosure by hand. Secure L2-RIGBAR to BPCHAIN 1.5T and slightly raise the assembly, then secure the other ends of the straps to L2-RIGBAR through the ball-locking pins in their storage position. Adjust the height so the straps are taut but the enclosure is still on the ground — keep the straps the same length on both sides, and make sure they are not twisted.

Turning and Cradling

Slowly and carefully raise the enclosure about 40 cm / 1.33 ft from the ground, then remove the pallet and bottom lid of the delivery packaging. Carefully turn the enclosure over. Position L2-CHARIOT/L2D-CHARIOT underneath the assembly, then carefully lower the assembly until the enclosure rests in the chariot. Secure the L2-CHARIOT/L2D-CHARIOT ball-locking pins. Unscrew the L2-ROLL rings from the enclosure by hand. On each side of the enclosure, tighten the screw at the center of gravity using the screwdriver with an 8 mm hex bit.

Source: L-Acoustics L2 Owner's Manual, EN, v5.0. Rigging procedures, pp.86-92.