PA Rigging / L-Acoustics / K3 / Mounting K3-CHARIOTLID to K3 for Transport

K3 — Mounting K3-CHARIOTLID to K3 for Transport

Fitting K3-CHARIOTCOV and K3-CHARIOTLID to a stacked block of K3 on K3-CHARIOT for transport. Reference: LA-K3-CHARIOTLID-MOUNT-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

Minimum 1 operator.
K3-CHARIOTLID load capacity: up to 400 kg / 881.8 lb.
Prerequisite: a block of four K3 is already stacked on K3-CHARIOT before starting.

0/ complete

Not saved anywhere — resets when you leave this page.

Mounting the Lid

Prepare the top enclosure for K3-CHARIOTLID: lift the front rigging arms and secure the ball-locking pin to the LINK position, then lift the rear rigging arms and secure the ball-locking pin to the 0.25° position. Put K3-CHARIOTCOV on K3, opening the top flaps to pull out the front and rear rigging arms of the top enclosure. Position one K3-CHARIOTLID on K3. Position the back of K3-CHARIOTLID on the rear rigging arms — the rear rigging arm must sit in the notch of K3-CHARIOTLID. Connect the front rigging arms of K3, securing the ball-locking pin to the front rigging arm.

Source: L-Acoustics K3 Owner's Manual, EN, v4.1. Rigging procedures, pp.107-109.