PA Rigging / L-Acoustics / K3 / Adjusting the K3-CHARIOT Site Angle

K3 — Adjusting the K3-CHARIOT Site Angle

Setting a positive or negative site angle on a K2-JACK-stabilized K3-CHARIOT. Reference: LA-K3-CHARIOT-ANGLE-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

Minimum 2 operators.
Tipping hazard: adjust either the front or the back stabilizer, never both at once.
Tighten stabilizer bolts by hand only.

0/ complete

Not saved anywhere — resets when you leave this page.

Adjusting the Site Angle

Verify the wheels are as close as possible to the ground without touching it. Loosen one stabilizer bolt and tighten the other depending on the target site angle — tighten by hand only. Adjust the site angle using the front screw jacks for a positive site angle or the back screw jacks for a negative site angle — tipping hazard, adjust either the front or the back stabilizer, never both. Tighten the front or back bolts depending on the site angle — hand-tight only.

Source: L-Acoustics K3 Owner's Manual, EN, v4.1. Rigging procedures, pp.100-101.