PA Rigging / L-Acoustics / K1 / Preparing a Block of Four K1/K1-SB

K1 — Preparing a Block of Four K1/K1-SB

Building a ground-stacked block of four enclosures on K1-CHARIOT before it is flown. Reference: LA-K1-BLOCK-PREP-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

Rigging accessory: K1-CHARIOT.
Minimum 2 operators.
Follow the same procedure for K1-SB enclosures.
K1-CHARIOT/K1-PLA are L-Acoustics K1/K1-SB-only accessories — use with other equipment may cause instability and injury.
Do not move or transport more than four K1 or K1-SB on K1-CHARIOT.

0/ complete

Not saved anywhere — resets when you leave this page.

Preparing a Block of Four K1/K1-SB

Position a first K1 on K1-CHARIOT (the enclosure can face either way). Secure the enclosure using the ball-locking pins. Position another K1 on the first one. On each side of the bottom enclosure, secure the front rigging arm to the top enclosure by sliding it out and securing it with the top enclosure's ball-locking pin. On each side of the bottom enclosure, secure the rear rigging arm to the top enclosure by rotating it and securing it with the top enclosure's ball-locking pin. Repeat positioning and securing the front and rear rigging arms until the block of four K1 is complete. On each side of the top enclosure, set the angle to 0° using the top ball-locking pin.

Source: L-Acoustics K1 Owner's Manual, EN, v4.0. Rigging procedures, pp.76-78.