PA Rigging / L-Acoustics / K1 / Presetting the Inter-Enclosure Angles

K1 — Presetting the Inter-Enclosure Angles

Setting the splay angle between each pair of enclosures in a K1/K1-SB block before it is flown. Reference: LA-K1-ANGLE-PRESET-01. Follow in order — this is a sequential rigging procedure, not an independent checklist; steps depend on the ones before them.

Follow the same procedure for K1-SB enclosures.
Nine angle positions are available: 0°, 0.5°, 1°, 1.5°, 2°, 2.5°, 3°, 4°, 5°.

0/ complete

Not saved anywhere — resets when you leave this page.

Presetting the Inter-Enclosure Angles

Make sure the automatic locking system is deactivated — if the latch is engaged, pull it to deactivate. If necessary, on each side of the bottom enclosure, remove the ball-locking pin from its current angle hole. Slide out the front rigging arm to the desired angle hole and insert the ball-locking pin. On each side of the top enclosure, press the angle locking button to lock the inter-enclosure angle — the latch slightly retracts when the button is pushed. Repeat for each inter-enclosure angle of the array.

Source: L-Acoustics K1 Owner's Manual, EN, v4.0. Rigging procedures, pp.79-80.